PPFD to PPF Calculator

PPFD is the light landing on your canopy. PPF is the total light behind it. Enter your average PPFD and the area it covers, or a reading under the light and its hanging height, to estimate the PPF your light is putting out.

How much light reaches the plants?

Not every photon a light makes lands on a leaf. Some hits the walls and some spills past the edge of the canopy, a bit like watering a pot with a hose: some water always misses. Reflective walls, like a grow tent's, bounce most of it back to the plants, about 85%. White walls keep about 70%, and an open space about 55%. These are rough numbers for planning, and the light's beam and hanging height shift them too.

What beam angle should I use?

The beam angle is how wide the light spreads, edge to edge, like the cone of a flashlight. The same light squeezed into a narrow beam gives far more PPFD in the middle than when it spreads wide. Bare LEDs and LED boards spread about 120°, which is a good start for most grow lights. Lenses and reflectors narrow it to 60–90°, so look for "beam angle" on the spec sheet. A bare bulb shines all around, so use 360°. The calculator spreads the light evenly across the beam, so the real center of a light with a hot spot reads a little higher.

PPF

from the light

1355

µmol/s

Area

your grow area

1.44

m²

How to convert PPFD to PPF

PPF = PPFD × Grow area (m²) ÷ Light on the canopy

PPF = PPFD × 2π × (1 − cos(Beam angle ÷ 2)) × Distance (m)², which is 4π × Distance² for a bare bulb (360°)

Use “By area” when you’ve measured PPFD across your canopy and know its size. Multiplying the average PPFD by the area works like a rain gauge. The depth in the gauge times the size of the field tells you how much water fell on it. That’s the light that lands on your plants. Your fixture has to put out more than that, because some light hits the walls or spills past the edge of the canopy, so the calculator divides by light on the canopy to get the PPF from the light. Set it to 100% to see only what lands on the plants. Comparing that with the spec sheet shows how much of the light you paid for reaches them. Average several readings across the canopy, since one reading right under the light will overstate it.

Use “By distance” when you only have one PPFD reading directly below the fixture, its hanging height, and its beam angle, how wide it spreads, like the cone of a flashlight. The calculator spreads the light evenly across that cone and works out how much PPF it takes to give your reading at that distance. Most LED grow lights spread about 120°, lenses and reflectors narrow it to 60–90°, and a bare bulb shines all around, 360°. Real beams are brightest in the middle, so a reading straight under the light makes the estimate run a little high.

Treat both methods as estimates for comparing setups, not as a lab measurement of the fixture. PPFD METER does the “By area” math for you. A PAR Map averages the PPFD from as many points as you capture across the canopy and reports the usable PPF over your grow area, with your phone or a Bluetooth LUX meter.