PPFD to LUX Calculator
Have a target PPFD in mind? Convert it to the LUX value your light meter should read under your light, worked out from its spectrum.
LUX
eye response
33209
LUX
ePPFD
400–750 nm
697
µmol m⁻² s⁻¹
How it's calculated
LUX measures light the way your eyes see it, and PPFD counts the photons plants use. The calculator takes the spectrum of the light you pick and reads it twice. Once through the eye's sensitivity curve, which gives its LUX, and once by counting its photons from 400 to 700 nm, which gives its PPFD, or to 750 nm for ePPFD, which adds the far red plants also use. The ratio of the two turns your number into the other one. That's why the light matters so much: deep red and blue make plenty of PPFD but very little LUX. This is a theoretical calculation, not a sensor reading. A phone's light sensor, its camera and a handheld LUX meter each see color a little differently from the eye's curve, most of all for deep red and blue, so each meter reports a slightly different reading. The PPFD METER app uses factors tested on each sensor it supports, so its readings are more precise.
About the photon bars
The bars split this light's photons from 400 to 750 nm into four bands, so you can see where it puts its light. Plants respond to photons, and the eye mostly to green and yellow, which is why two lights with the same LUX can drive photosynthesis very differently.
About the chart
The colored shape is the light's spectrum, scaled to its own peak. The dashed line is the eye's sensitivity curve, the one every LUX reading is weighed by. It peaks in yellow-green at 555 nm and falls almost to nothing in deep blue and deep red. Light under the curve counts fully toward LUX. Plants still use the light outside it, but LUX hardly sees it.
How to convert PPFD to LUX
LUX = PPFD (µmol m⁻² s⁻¹) × the light's lumens ÷ its photons from 400–700 nm
LUX = ePPFD (µmol m⁻² s⁻¹) × the light's lumens ÷ its photons from 400–750 nm
Use this when you know the PPFD you want and your meter reads in LUX. Every light has its own rate between the two, set by its spectrum, so pick your light first. Say you want 600 PPFD under average midday sunlight (D65). Your meter should read about 33200 LUX. Under a deep red 660 nm LED the same 600 PPFD reads only about 6160 LUX, because the eye, and so a LUX meter, barely sees deep red.
Your target can be a PPFD (400–700 nm) or an ePPFD (400–750 nm, which adds far red); pick which one you have above the number. The same light gives fewer LUX per µmol of ePPFD, since the far red it adds is light the eye hardly sees.
The rates for each light, why color LEDs are the extreme case, and how close these estimates get are on the LUX to PPFD calculator. Use this page to plan a target or size up a light before you buy. When you need a reading from your own setup, PPFD METER measures it live with factors tested on each sensor it supports.
Switch to Imperial above if your meter reads in foot-candles instead of LUX. 1 foot-candle ≈ 10.76 LUX, and the result converts automatically.