PPF to PPFD Calculator

PPF is the total light a fixture puts out. PPFD is what your plants see at canopy level. Enter the fixture's PPF and either the area it covers or its hanging height to estimate the PPFD you're getting.

How much light reaches the plants?

Not every photon a light makes lands on a leaf. Some hits the walls and some spills past the edge of the canopy, a bit like watering a pot with a hose: some water always misses. Reflective walls, like a grow tent's, bounce most of it back to the plants, about 85%. White walls keep about 70%, and an open space about 55%. These are rough numbers for planning, and the light's beam and hanging height shift them too.

What beam angle should I use?

The beam angle is how wide the light spreads, edge to edge, like the cone of a flashlight. The same light squeezed into a narrow beam gives far more PPFD in the middle than when it spreads wide. Bare LEDs and LED boards spread about 120°, which is a good start for most grow lights. Lenses and reflectors narrow it to 60–90°, so look for "beam angle" on the spec sheet. A bare bulb shines all around, so use 360°. The calculator spreads the light evenly across the beam, so the real center of a light with a hot spot reads a little higher.

PPFD

averaged over the area

708

µmol m⁻² s⁻¹

Area

your grow area

1.44

m²

How to convert PPF to PPFD

PPFD = PPF × Light on the canopy ÷ Grow area (m²)

PPFD = PPF ÷ (2π × (1 − cos(Beam angle ÷ 2)) × Distance (m)²), which is 4π × Distance² for a bare bulb (360°)

Use “By area” when you know roughly how much canopy the fixture is meant to cover, the footprint from a spec sheet, for example. This spreads the light that reaches the plants evenly across that whole area, the same way you’d spread a paycheck evenly across a month. Not all of a fixture’s PPF gets there, since some hits the walls or spills past the edge, so pick your space under light on the canopy. Real fixtures don’t distribute photons that evenly. Output is almost always higher directly underneath the light and falls off toward the edges, so this gives you an average, not the reading at any one point.

Use “By distance” when you only know the fixture’s PPF, how high it hangs above the canopy, and its beam angle, how wide it spreads, like the cone of a flashlight. The calculator spreads the PPF evenly across that cone and gives the PPFD in the middle of the beam at your distance. A narrow beam packs the same photons into a smaller spot, so the PPFD under it climbs. Most LED grow lights spread about 120°, lenses and reflectors narrow it to 60–90°, and a bare bulb shines all around, 360°. Real beams are brightest at the center, so a sensor straight under the light reads a little higher. It counts only the light coming straight from the fixture, so in a tent, where the walls bounce some back, the real reading is higher.

Treat both methods as a starting point for comparing fixtures on paper, not as a substitute for a quantum sensor reading at canopy height. Manufacturer PPF numbers are usually measured in an integrating sphere under lab conditions and can run optimistic next to what a fixture delivers once it’s hung, dimmed, and running warm in your grow space. PPFD METER gives you a reading from your own setup, with your phone or a Bluetooth LUX meter, at as many points across the canopy as you want, so you’re growing off measurements instead of a spec sheet.