Lumens to LUX Calculator

Know a fixture's total lumen output from the spec sheet? Convert it to LUX over the area it's lighting, or at a distance and beam angle.

What beam angle should I use?

The beam angle is how wide the light spreads, edge to edge, like the cone of a flashlight. The same light squeezed into a narrow beam gives far more LUX in the middle than when it spreads wide. Bare LEDs and LED boards spread about 120°, which is a good start for most grow lights. Lenses and reflectors narrow it to 60–90°, so look for "beam angle" on the spec sheet. A bare bulb shines all around, so use 360°. The calculator spreads the light evenly across the beam, so the real center of a light with a hot spot reads a little higher.

LUX

averaged over the area

3472

LUX

Area

your grow area

1.44

m²

How to convert lumens to LUX

LUX = Lumen ÷ Grow area (m²)

LUX = Lumen ÷ (2π × (1 − cos(Beam angle ÷ 2)) × Distance (m)²), which is 4π × Distance² for a bare bulb (360°)

“By area” spreads the lumen output evenly across the area you enter, assuming all of it lands there. In practice some hits the walls or spills past the edge, so real readings average lower. Real fixtures concentrate more light directly beneath them, so actual LUX readings will be higher near the center and lower toward the edges of your canopy.

“By distance” spreads the lumens evenly across the light’s beam, a cone as wide as its beam angle, and gives the LUX at that distance in the middle of the beam. A flashlight works the same way. Twist it to a narrow beam and the spot gets brighter, though the bulb makes the same light. Most LED grow lights spread about 120°, lenses and reflectors narrow it to 60–90°, and a bare bulb shines all around, 360°. Real beams are brightest at the center, so a meter straight under the light reads a little higher. Useful for ballpark comparisons, not a substitute for a meter.

Switch to Imperial for foot-candles (FC) and inches instead of LUX and centimeters, with the area in square feet.