LUX to Lumens Calculator

LUX measures light falling on a surface; lumens measure the total light a source puts out. Enter the LUX reading and the area it covers, or the distance and beam angle, to get the lumen output.

What beam angle should I use?

The beam angle is how wide the light spreads, edge to edge, like the cone of a flashlight. The same light squeezed into a narrow beam gives far more LUX in the middle than when it spreads wide. Bare LEDs and LED boards spread about 120°, which is a good start for most grow lights. Lenses and reflectors narrow it to 60–90°, so look for "beam angle" on the spec sheet. A bare bulb shines all around, so use 360°. The calculator spreads the light evenly across the beam, so the real center of a light with a hot spot reads a little higher.

Lumens

light landing on the area

1440

lm

Area

your grow area

1.44

m²

How to convert LUX to lumens

Lumen = LUX × Grow area (m²)

Lumen = LUX × 2π × (1 − cos(Beam angle ÷ 2)) × Distance (m)², which is 4π × Distance² for a bare bulb (360°)

Use “By area” when you’ve measured LUX evenly across a known surface, like a canopy. It assumes the reading is even across the whole area; real fixtures spread light unevenly, brighter in the center and dimmer at the edges, so treat this as a ballpark for comparing specs rather than a substitute for measuring several points.

Use “By distance” when you’ve taken a single LUX reading directly below a fixture and want to estimate its total output. Enter how far the meter was from the light and the light’s beam angle, how wide it spreads, like the cone of a flashlight. The calculator spreads the light evenly across that cone, so a narrow beam needs far fewer lumens for the same reading than a wide one. Most LED grow lights spread about 120°. A bare bulb shines all around, 360°. Real beams are brightest in the middle, so a reading straight under the light makes the estimate run a little high. It’s best for comparing lights, not as a spec sheet number.

Switch to Imperial for foot-candles (FC) and inches instead of LUX and centimeters, with the area in square feet. Lumens themselves don’t change between unit systems, only what you type in does.