Lumens to PPF Calculator
Know a light's lumens but not its PPF? Enter the lumens and pick the kind of light, and the calculator converts through its spectrum to the PPF, the photons for plants it puts out every second.
PPF
400–700 nm
137
µmol/s
ePPF
400–750 nm
140
µmol/s
How it's calculated
Lumens measure light the way your eyes see it, and PPF counts the photons plants use, every one the light puts out each second. The calculator takes the spectrum of the light you pick and reads it twice. Once through the eye's sensitivity curve, which gives its lumens, and once by counting its photons from 400 to 700 nm, which gives its PPF, or to 750 nm for ePPF, which adds the far red plants also use. The ratio of the two turns lumens into PPF. That's why the light matters so much: deep red and blue make plenty of PPF but very few lumens. This is a theoretical calculation from typical spectra, not a measurement of your light. If its spec sheet gives a PPF, that number is the better one.
About the photon bars
The bars split this light's photons from 400 to 750 nm into four bands, so you can see where it puts its light. Plants respond to photons, and the eye mostly to green and yellow, which is why two lights with the same lumens can drive photosynthesis very differently.
About the chart
The colored shape is the light's spectrum, scaled to its own peak. The dashed line is the eye's sensitivity curve, the one every lumen is weighed by. It peaks in yellow-green at 555 nm and falls almost to nothing in deep blue and deep red. Light under the curve counts fully toward lumens. Plants still use the light outside it, but lumens hardly count it.
How to convert lumens to PPF
PPF (µmol/s) = Lumens × the light's photons from 400–700 nm ÷ its lumens. ePPF: the same, with photons from 400–750 nm
Lumens and PPF both count the light a lamp puts out every second, but for different eyes. Lumens weigh each photon by how bright it looks to a person, so green and yellow count the most and deep red and blue hardly count at all. PPF, the photosynthetic photon flux, counts every photon from 400 to 700 nm the same, because a plant uses them all. It’s like judging a fruit basket by how sweet it tastes instead of counting the fruit. PPF is often called a light’s PAR output, so this is the lumens to PAR conversion too.
That’s why there’s no single lumens to PPF factor. The calculator takes the spectrum of the light you pick and works out its own ratio. 10000 lumens from a 3500K white LED is about 137 µmol/s, from an HPS lamp about 117, and from a 660 nm deep red LED about 973. A white LED’s color temperature moves it a little, from about 136 to 159 µmol/s per 10000 lumens. A color LED moves it a lot. A mixed light, like a white LED with extra red, sits between its parts, so pick the white closest to it and treat the result as a floor.
ePPF counts to 750 nm instead of 700, adding the far red that plants also use. White LEDs and HPS have little of it, so their ePPF is close to their PPF. Halogen has plenty: 10000 lumens of it is about 196 µmol/s of PPF and 276 of ePPF.
PPF is everything the light puts out, not what lands on your plants. To see the PPFD on your canopy, put the PPF into the PPF to PPFD calculator with your grow area. Divide the PPF by the watts the light draws, and you have its efficacy in µmol/J, the number the Grow Light Wattage Calculator asks for. If the light’s spec sheet gives a PPF, use that instead: it was measured on the real fixture, while lumens are converted from a typical spectrum.